How to solve the slippage of PTFE conveyor belt?

PTFE mesh conveyor belt has excellent properties such as weather resistance, aging resistance, high temperature resistance, high viscosity, non-adhesive surface wear resistance and environmental protection. very broad. Let's take a look at how to solve the slippage during the use of Teflon conveyor belts?

1.If the initial tension is too small, the tension at the point where the conveyor belt leaves the drum is not enough to cause the conveyor belt to slip. This situation generally occurs during startup. The solution is to adjust the tensioning device and increase the initial tension.

2.Most of the slippage is because there is water on the conveyor belt or the environment is wet. The solution is to add some rosin powder to the roller, but be careful not to use your hands, it should be blown in with a blower device.

3.The tail roller bearing is damaged and does not rotate or the upper and lower idler bearings are damaged and cannot rotate. The reason for the damage is that the tail floats too much, and the damaged or inflexible parts are not repaired and replaced in time, which increases the resistance and causes slippage.

4.If the startup speed is too fast, it can also cause slippage. At this time, it can be started at a slow speed. If a squirrel cage motor is used, it can be jogged twice before starting, which can also effectively alleviate the slippage phenomenon.

5.If the load of the conveyor belt is too large, it will also slip if it exceeds the capacity of the motor. The advantage of slipping at this time is that it protects the motor, otherwise the motor will be burned for a long time. But for operation, a slip accident may occur.

Rubber Tube for Air Shaft,Flat Transparent air shaft rubber tube,Corona Treater Sleeves In Microcomputer,Anti Static PTFE Coated Fabric,Anti Static PTFE Coated Fabric,Non Stick Baking Sheet Liner,Rubber Hose For Air Shaft,High Temperature PTFE Fabric For Conveyor Belt